Machined plastic parts.
Price now, made in Wauconda, Illinois.
Milled and routed from Delrin, UHMW, HDPE, nylon and PEEK. Upload a STEP file and see the price; no account, no call. Over 100 pieces, the engineer who will run your job quotes it within 24 hours. No CAD at all? Send us the part.

Three ways in. Pick the one that matches what is in your hand.
I have a CAD file
Upload a STEP or STL and the price is on the screen in a few seconds. Up to 100 pieces you can pay by card.
Get an instant quote →I have a drawing and a quantity
Over 100 pieces, or a print with no model. Send the drawing and the quantities you would buy. A person prices it within 24 hours.
Request a firm quote →I have a worn part and no drawing
You do not need a drawing. Tell us what the part is and what machine it came off, then send us the part. We measure it and send you a price.
No CAD? Send us the part →Three ways to make a plastic part. The quote tool prices all three.

CNC Machining
Blocks, brackets, housings, wear pads and guides. Parts up to 18" × 9.5" × 12" price online. Plastics first; 6061 and brass for the part that mates with yours.

CNC Routing
Flat parts cut from 4' × 8' sheet, with pockets, holes and counterbores in the same setup. Usually the cheapest way to make a flat plastic part in quantity.

3D Printing
Prototypes, fixtures and short runs. Print the fit check first, then machine the production part from the same file.
Milled, routed and printed plastic.






No sales call unless you want one.
Upload
Drop in a STEP, STL, IGES or 3MF. No account is needed to see a price. The file is encrypted at rest and purged on a schedule if you do not order.
Price and DFM
Pick process, material, finish and quantity. The price updates as you go, with a manufacturability check against the limits printed on this site.
Check out, or get a firm quote
Up to 100 pieces: check out with a card. More than that, an oversize part or anything the check fails: a firm quote from a person within 24 hours.
Made, then shipped
Need a first-article inspection report and a certificate of conformance? Tick the box on your quote and they ship with the parts; the price shows before you pay. Your order page shows where the job stands.

Plastics move. Buy the part with that in mind.
- Plastic expands five to ten times as much as steel for the same temperature change. A long HDPE or UHMW part is a different length on a warm line than in a cold shop.
- Nylon takes on water and grows, up to about 2% in length when saturated.
- Most plastics relax after they are cut. A part measured warm off the machine can read differently the next morning.
- So tell us where the part lives, and put the tight tolerance only on the feature that needs it.
Standard tolerance here is ±0.005" on acetal, ±0.010" on UHMW and HDPE. The machining page has the table, with what moves each plastic.
What gets checked, and howWauconda, Lake County, Illinois.
Lake County, the northern suburbs, Kenosha and Milwaukee are a drive. Everywhere else is a box. Local pickup: call first. Central time. 847-260-8104
Have a print? Send it.
No print? Send us the part. Either way you reach the engineer running your job.